thanks andy.
continue with the work that has been arduous, do not publish anything to be bundled with the plane, making the wings, I remember your friend Luis Carlos so you can see how I make the lights, then the joints of the wings to the fuselage it has been complicated to place them and they will be fine since they do not have fixation. They have to be adjusted so that they remain with the dihedral and not much separation in the union. After this I had to place a few fixings to the ailerons I do not want to be as with the wings and it is very simple, a holes of 0'8mm and round bar abs, the antennas, the mast has been fixed with a copper wire 0'2mm and cyano, inside has been simulated as the input of the antenna, and the VHS antenna, has been left a piece of the injected has been retouched so that it is the size of the hole that has been made 0'8mm and it's stuck, that's how everything is.....
I'm going to explain a little the process of making headlights:
I measure the hole where the lighthouse will go, with the vernier caliper
I check that the bit goes well, since it can not enter forced
with a punch of two numbers above, in this case the bit is 2mm the punch is 3/15 ", I take a piece of aluminum foil.
I check that it is correct and that it covers enough.
I place the cyano around so I can better shape the headlight refractor
So it looks before giving it the form
as the bits have the back is conical has a shape that gives us the almost exact shape so I give a little pressure to stretch just the aluminum and that round shape of the back
As you can see behind the photos there is a broken airbrush needle, because with it in the center I make a deformation that simulates the luminary or lamp
and the rest of the photos without more: