Good work there Magnu!
What's on The Workbench
- Thread starter Heinz
- Start date
Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
looks good Magnu !
ok here the progress on my Ki-84, tried a bit of drybrushed aluminium for weathering, then a gloss coat, staert the decals next which include a full length white band overlayed with a full length red one !!!!!!!!
ok here the progress on my Ki-84, tried a bit of drybrushed aluminium for weathering, then a gloss coat, staert the decals next which include a full length white band overlayed with a full length red one !!!!!!!!
Attachments
If you have any trouble with the stripes Karl cut them in to sections that match to panel lines and do a section at a time, if you were to choose this do it carefully to get a straight line, use a thin cut strip of cardboard to get your alignment won't damage anything and will bend to the curve of the fuselage.
Remember this is plan B.....hope plan A works!
Remember this is plan B.....hope plan A works!
plan "A" ????????
plan "A" ????????
You know...Plan A!...the whole white stripe slides nicely off the backing paper and goes into place without a hitch!! Ditto on the RED!
You got it now!
You know...Plan A!...the whole white stripe slides nicely off the backing paper and goes into place without a hitch!! Ditto on the RED!
You got it now!
never once considered that might happen
Quick update on the mustang/s I have decided to do the Hasegawa, currently OD nose as Petie 2nd and the Tamiya as Nookie bookie IV as the exhaust stacks on the Hasegawa kit were already in place and did not want to be removed these were incorrect for the P51K. The Tamiya kit which was to be Petie2nd has not had the exhausts fitted. I have also managed to rescue the cockpits on both and have started to mask them up ready for the change of identity
Airframes
Benevolens Magister
Looking good mate.
Keep up the good work mate!
Managed to get a bit more done today sprayed the blue and OD to switch the IDs. Cleaned up the joins in the spinners and painted them the appropriate colours. Gave both fuselages a coat of Citadel Bolt gun metal, and the wings in Mithril silver. Lost some of the blue when I took the masking off so that will have to have a touch up. Dirtied up the wheel wells on Petie 2nd and gave the rear wall a coat of zinc chromate
8)
Airframes
Benevolens Magister
Great stuff mate.
dirkpitt289
Master Sergeant
Next up is something a little different for me and much smaller than I'm use to. The Academy Mini-craft B-17J in 1/144. In recent months I've purchased quite a few of these 1/144 bombers but have yet to crack one open. I figure now is as good as any right?
Even in this scale i can't leave well enough alone. I decided to cut the engine cowl flaps.
Even in this scale i can't leave well enough alone. I decided to cut the engine cowl flaps.
Give it plenty of time to dry Rob...you don't want finger prints in the finish....looks ok so far!
Last edited:
A4K
Brigadier General
Great work guys!
