Got a few things going.
Have filled the gap at the wing join at the fusey, as well as fitting the ailerons.
Because I wanted to open the floor part to be only frame I couldn't attach the back wall to the floor so I had to fit and attach to the fuselage, then file at fit to the port side inside. I've attached the resin seat, has belts molded in. The starboard side tube frame has been de-flashed and fitted with throttle quadrant and trim crank?
Working on the port tube frame, and it's attachments.
BTW................. by the diagrams for the sprue on the instructions, parts are listed as from sprue C, in the build steps they are shown to be on sprue B.............. Duh!
I also wonder if Paul found the surface finish on a lot of parts like they were gouged with a wire brush? A lot of sanding to smooth a lot of parts surface areas.....
I sailor on.