I have also started the Airfix 1/24 Typhoon car door . Right from the start the first problem encountered was that the spars procedure was shown backwards and of course I followed that procedure and discovered that it was wrong and had to remove a lot of the glued pieces including the spars causing considerable damage to everything. I was unable to re glue the rear spar and hope that when It gets to mounting the wings it could be fixed. Meanwhile I emailed Airfix offering to buy sprues A and B to restart the project correctly. although the cabin area doesn't look too bad and it will not be seen anyway once assembled . This kit requires a lot of checking assemblies further ahead before gluing anything. I have also ordered the 1B bubble version for a later build. Unfortunately I know the mistakes that were encountered and the fix is not the greatest, so I may end up buying another one and hope to do it right. Some parts were missing on the sprue, specifically part # A22 mounting bracket so I drilled out a piece of sprue and replaced it.The flash is not too bad.