**** DONE: 1/48 Bf109F-4 J.Steinhoff - Your Favorite Aircraft of All Time GB (1 Viewer)

[Aaron Brooks Wolters]

WHOA!!!! That looks spectacular Andy! Very nice work sir!

 

[Wayne Little]

Some fine work there Andy!

 

[Airframes]

Very nice work indeed Andy! not sure what the small tank is, but I'll see if I can find out. Note that the blast tubes at the gun muzzles, which mate with the cowling troughs, were normally painted the interior colour, RLM02/66. Also, most photos of the exhausts show the first stub to be painted, colour shots suggesting RLM02. I'm guessing they might all have been painted at one time, but hot exhaust gases burnt off the paint on all but the front one.

 

[meatloaf109]

great plumbing!

 

[Crimea_River]

Thanks guys. I really appreciate the feedback.

Terry, thanks for the tips. I should have mentioned that I had not adressed the guns yet, other than slapping some paint on them. I've yet to add the synchronization wiring to them and I'm still debating whether or not to enhance the port blast tube - hence there being no paint on these.

 

[rochie]

looks fantastic Andy

 

[Crimea_River]

Thanks Karl. Hope to get a bit more done on it today.

 

[woody]

Good looking engine Andy.

 

[javlin]

That is looking quite spiffy Andy. Nice Work Sir!

 

[Gnomey]

Great work on the engine there Andy!

 

[Vic Balshaw]

Time well spent Andy.

 

[Lucky13]

Awesome work!

 

[Wurger]

 

[Crimea_River]

Thanks once again guys. I've now almost completed the engine compartment now that the guns have been wired up and a few details added. The first pic shows the unpainted bits that were added based on reference pics. Note that work on the starboard side was minimal, if non-existent, since this area will only have limited visibility due to the cowl on that side remaining closed. The blast tube was made of rolled paper and the clamps are aluminum tape. Stretched sprue, card, and copper wire, some of it pre-painted, make up the rest of the firing mechanism connections and synchronization gear.

The last pic shows the same assembly with paint applied.

 

[Rogi]

Awesome I love the engine detail

 

[Wayne Little]

bewdy mate!

 

[Vic Balshaw]

I do believe YOU really are going to make this one fly. Awesome work Andy.

 

[Airframes]

Great stuff Andy, looks the biz.

 

[Crimea_River]

Thanks guys. WQill move4 onto the cockpit next. Seems I might get onto using some Hasegawa 109 G sidewalls modified to suit. ICM walls are sparse and the Eduard PE was designed for the Hasegawa kits which have more detail including oxygen regulator and more trim wheel stuff. Needs a bit more planning before launch.

 

[A4K]

Great work Andy, and that tank was for the radiator coolant.