I've been working on the oil pan on and off for a couple weeks now but I don't have enough to post yet, but I thought I'd take advantage of my down time to upgrade my 3D printer. And of course, what is the first thing I have to print? Take a guess:
It's currently an hour and a half into an estimates 44 hour print. Wish me luck. Say a prayer to the kami of 3D printers.
I gave up on the CR-10S printer it just never worked well and never gave an adequate result. So I switched to an Anycubic Photon Mono X, and I gotta say, I'm a bit giddy with the results.
You can see a couple galleries of the two prints I have done on it below:
I decided that in order to finance this little project of mine I would make some aftermarket engines for some of the larger scale models out there that don't really have good Merlin engines. Just for fun I printed one in 1/8th scale and was just gobsmacked at the results. So I also plan to try and make an even larger scale standalone engine kit, probably in 1/8th or even 1/6th scale.
I am currently working on the lower crankcase assembly, a.k.a. the oil pan. I will update you guys that once I have completed the casting. Thanks guys!
I basically plugged it and didn't even print a test print. These were my test prints and they were perfect at stock settings. Now, that said, resin 3D printing requires a good deal of cleanup and the resin can give you a nasty rash if you get it on your skin, so it requires a breather mask and latex gloves and a lot of 99% isopropyl alcohol. But it is still 1000% easier than FDM printing, a.k.a. PLA and ABS printing.
Just a brief update to let you know I've finished the Lower Crankcase, a.k.a. oil pan, casting. I've put it up on my grabcad page if anyone wants to see it.