the outputs of the pipes, are removed and placed round the trapezoidal bearing the model is placed side shields for optional equipment, are placed and the union entredas cardand walking the roof, it's finally put the plastic jump straight to eliminate having and wide enough to give the clear. separation was nearly 2mm of each other.
as the decals arrive to continue the aircraft before starting another new project I decided to finish this.
It has cost me a lot time adjusting well all over the whole panel was more accomplished and I had to redo all done and ride see the front transparent is very short but good all solvable, later what you will see.
under the black is painted gray inside to seal the black is the color
Here you can see the finished board and placed
Here you see the hole transparent, little one, little one.
I still have photos to upload, I hope to upload tomorrow
finish painting the pege tailgate into position, the rotors in their present position, they are not glued are only subject with a little blue-track,
seen here I will say that the gate is very close but not so the helicopter will not go straight but I'm working on part perform a Wasp Cover and place of sigueinte way: