it does look quite good at normal scale, though the perfectionist in me always wants more.
Last night I did little more, Glues the two halves together, and then hit a minor snag. The rear sill is supposed to sit on a small lip in the hobby boss (???) kit. The Frog Kit doesnt have thet, so to hold the sill plate in place I scratch built a support post to hold it in place (not seen). It was a bit tricky, because I had to cut and trim the support to the right height so that the sill plate sat nice and flush. Still not quit right, but within the possiblity of filling.....
Another problem is that the cockpit well is not quite sitting square in the fuselage so this has created a bit of a gap on the port side behind the rear firewall, but again I think that can be filled.
The two ejection seats detached during the fitting foe sill, but no damage. gives me the opportunity to touch up the harness colurs a bit to give better definition to the edges of the harness. Any suggestons about how to achieve that through drybrushing, or am I just fussing???