Thanks very much Guys.
...well I was keeping this simple too wasn't I...running out of time too.....and then I decided nah, can't leave it as is...do it...so away i went and added some detail to the ineer doors of the undercarriage bay....
First I sculptured a couple of plasticard bits to fit inside the door sections, then I drilled some holes in them and carefully cut the centres out to shape without cutting my fingers while holding them, now remember just how small these bits are too!
Glued them in place, also added two TINY triangular pieces after carefully cutting a slot for them to fit into on either side....cut and bent the corner piece of the cover too, next up I drilled holes in the sides of these triangles. Finally bent a small piece of brass rod to shape and fitted this to the cover, first part complete!