**** DONE: GB-51 1:48 Lockheed S-3B Viking - No Propellers

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

Thanks guys. Still playing with the small bits. I want to get this all completed before I head back in tomorrow night so that I can paint when I get back. Another attachment point that drives me carazee. Right tight against the weapon mount


A test drive shows that the pylons didn't fit nicely to the wing so some work will be required
 
Nice job on the build George. Also thanks for the tip with the clone tool. I have a smaller light box and always have that problem with the background.
 
Last edited:
Thanks guys. Added the ECM pods to the wings and had a slight fit problem. The pods are supposed to line up with the panel line.


What Italeri doesn't show you is that the wingtip light needs to be removed first


Easy peasy.


Getting closer to the paint stage

 
Thanks all. Canopy masked and attached


I was studying the photo on the front page to figure out where to attach the remaining antennae when I noticed a protruding hatch on the lower right fuselage. According to Lock-On, this is one of the compartments that houses some ECM equipment and is not included on the model but is on my aircraft


So be it


I'll let this setup, do the antennae and then throw paint at it
 
Thanks guys. Continuing to add what Italeri left off. This time the parts are there but not shown in the instructions. The pitots are also seen on the aircraft photo above. There are diagrams of the parts trees showing the pitot tubes and are numbered #20 but as shown below are actually #29

 

Users who are viewing this thread