**** DONE: Revell 1/48 P-40B RAF 112 Squadron in Egypt in 1941 MTO Group Build

[Wurger]

OK Harry I believe. Make the wire more straight.

Tell me please do you use the macro option for taking oics?

 

[B-17engineer]

Yes. That was just a terrible pic

 

[Wurger]

OK. Make three more a such lengths of the wire.

 

[B-17engineer]

2 more you say!

 

[Wurger]

Harry you need four of these ( for each flap two ones right.)

 

[B-17engineer]

OK.

 

[B-17engineer]

..

 

[Wurger]

All right...When you have these wires prepared , measure 10mm off from one of the ends of a wire.Then bend it a little bit like in the diagram below.Don't cut out anything yet.Try to fit a wire length to the wing.Remamber about these lines you drew.

 

[B-17engineer]

Ok. I didn't drill a whole in the other wings bay or flaps yet. Was I suppose to ?

 

[Wurger]

Later Pal.We will do it to the has already drilled flap firstly.Then you can do that and mount the second one yourself.

 

[B-17engineer]

Fitted.

 

[Wurger]

OK Harry If you think all is fine with these wires.Apply some the CA gell on the 10mm length of the wire and stick it to the wing as shown in the pic below.Remember to make these wires line up with the marks you drew on the wing .

 

[B-17engineer]

Sure. Both holes in the wing?

 

[B-17engineer]

The one on the eight side will be a problem, because there is a drop off. The wall isn't there, it just curves into the cockpit, so what do I do?

 

[Wurger]

These wires have to be glued to the inner side of the bottom half of the wing.So there shouldn't be any problem to stick them at these places.

 

[B-17engineer]

Ok. Here it goes!

 

[Wurger]

How deep can you go with the wire there?

 

[B-17engineer]

Up till the leading edge but I just glued one...

 

[Wurger]

OK.

 

[B-17engineer]

Picture one: The gap I speak about. You can see the line.

Pic 2: Glued.