**** DONE: Revell 1/48 P-40B RAF 112 Squadron in Egypt in 1941 MTO Group Build

[B-17engineer]

I will try fixing this when I get back from church. Well, I'm off.... have a nice day!

 

[Wayne Little]

Lot's of good learning going on here!

 

[B-17engineer]

I had to redo the putty where the yellow is show. It wasn't strong enough. So I did it last night and sanded this morning, I did a bit of work on the symmetry.

 

[Wurger]

Excellent Harrison.

Here the next pic....

 

[vikingBerserker]

Lot's of good learning going on here!

I totally agree. My putty jobs are getting better and better just reading this thread.

 

[B-17engineer]

Alright! I'll do this

 

[Wurger]

To be honest you have to sand both sides in order to get the correct shape in the cross-section. But the marked one has to be sanded a little bit more.

 

[B-17engineer]

Ok, very good

 

[B-17engineer]

Is this better. I know it's not done but am I on the right track?

 

[Wurger]

Yes you are on track.But the air intake was circled in its cross-section.Like in the pic below.Can you see that? You made it a little bit too flat.

 

[B-17engineer]

Arg, so what do I do ? Keep sanding or leave it?

 

[Wurger]

Show me it from another direction,please.

 

[B-17engineer]

 

[Wurger]

The first is nice but blurred to much.I can't see it .

 

[B-17engineer]

Yes, I'll try again.

 

[B-17engineer]

Resized. And with a towel in the back

 

[Wurger]

Harrison try to make the red marked edge on both sides much rounded.Simply round the upper and partially sides at the upper areas.

 

[B-17engineer]

Ok!! I will go try that.

 

[B-17engineer]

Lightly, lightly

 

[Wurger]

Harrison take your pics from farther distance.Look at the newspaper.It can be seen very good while the fuselage is blurred.And always take a pic of lightened side.