**** DONE: Revell 1/48 P-40B RAF 112 Squadron in Egypt in 1941 MTO Group Build

[Wurger]

....

 

[B-17engineer]

It's on both sides of the plane. in the same spot.

 

[Wurger]

But are these on ailerons or moulded with flaps?

 

[B-17engineer]

I'm lost. That tiny little dot? the arrow is pointing at. If yes that was molded with the wing.

 

[Wurger]

Exactly Harrison the small dot on the ailleron.So isn't it the flap part?

 

[B-17engineer]

No those were glued onto the upper half of the wing earlier. So those aren't part.

I have to eat dinner, so if your on for further instruction cool! But if your not have a nice night, and my best to you and your family.

 

[Wurger]

Bon Appetit !!!

Tell me can you remove these flaps? How did you attach them to the wing? Do you have sandpaper of a few different grades?

 

[B-17engineer]

I could try removing them, I don't know how well it'd go but anything is possible. Yes I have different grades of sandpaper and I used Plastic cement for attatching them

 

[Wurger]

OK. Did you glue these flaps along their leading edges or at their sides only?

 

[B-17engineer]

just these little bits sticking out on the sides. Nothing else. Like the thing your arrow is pointing to I glued those.

 

[Wurger]

OK. Try to remove these flaps very gentiy.

 

[B-17engineer]

Crosses fingers. I'll try!

 

[B-17engineer]

Ok Wojtek, just went up and tried. I remembered they are glued to the underside of the fuselage and I attatched the top half so the only way would be to cut it from the plane with my knife.

 

[Wurger]

Stop

 

[B-17engineer]

See post about ^

 

[Wurger]

Yiour knife can be too much thick. DO you have a razor blade?

 

[B-17engineer]

My knife isn't too thick I don't believe it fit when I went to see. I'm not sure about the razor blade. My dad isn't getting home until later.

 

[Wurger]

So OK.

 

[B-17engineer]

Ok let me go do that.

 

[Wurger]

I keep my fingers crossed.