**** DONE: 1/48 Curtiss P-40 N "Hep Cat" 75 Sqdn RAAF Commonwealth GB

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

I like it Karl! Just putting on the flat will make it look even better. You might try messing around with pastels after the flat if you want an even more faded, worn look. I'm going to do that with mine. If you don't like it, just wipe it off with a damp towel. Olive drab didn't seem to ware to well, especially in very sunny conditions so I think just about any amount of fading you would want to do would seem realistic.
 
thanks Bill.

masked and attached the canopy last night, going to paint them today.
also started the decals but had to stop as part of the code letters go over part of the painted section of the canopy parts .

should get the decals 99% finished today, then start attaching the landing gear and the last little bits
 
as i promised slave driver Wayne, here's my morning's work

i know there is a step at the canopy join i might try and smooth that out with PVA glue !

the decals are all just settling down so i hope to start adding the landing gear tonight or maybe in the morning

the over painted serial numbers were added one at a time then the GA laid over the top, which was i bit of a pain.

one question, the fairings for the landing gear on the wing leading edges, were they painted grey or the same as the upper surfaces ?
 

Attachments

  • Picture 001.jpg
    52.8 KB · Views: 97
  • Picture 002.jpg
    45.9 KB · Views: 103
  • Picture 003.jpg
    41.1 KB · Views: 89
  • Picture 004.jpg
    56.1 KB · Views: 108
one question, the fairings for the landing gear on the wing leading edges, were they painted gray or the same as the upper surfaces ?

I've seen them gray, green, of Half and half. It you don't have reference pics to see it I guess it would be your choice.
 

Attachments

  • 4.jpg
    15.8 KB · Views: 100
  • 3.jpg
    28.3 KB · Views: 115
  • 2.jpg
    21.2 KB · Views: 94
  • 1.jpg
    29.9 KB · Views: 112

Users who are viewing this thread