- Thread starter
-
- #81
Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
The cause of that problem was the opposite. The file made the wing roots too straight and the wing side joint kicked out toward the front. The left side shows better where the joints didn't match. The gap on the right side was about the same until I started fixing the dihedral, then it opened up a lot more. Neither should be noticeable after painting. That thick CA does a wonderful job as a filler.Just guessing that you might have had a tough time keeping that file flat against the plastic and that the gap near the leading edge could be a result. Nonetheless, looks like a straight forward fix.